Magnetic Cable Clip for LINAK Desk Frame 2
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Flat magnetic cable clip for the steel foot of a LINAK Desk Frame 2. Two Ø10×2 mm magnets, no screws, no supports.
- Rating
- 0 / 5
- Likes
- 2
- Downloads
- 3
- Makes
- 0
- Views
- 7
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Office
- License
- Creative Commons — Attribution
🇩🇪 Deutsche Beschreibung weiter unten.
Flat cable clip for the steel foot of a LINAK Desk Frame 2. Held by two magnets – no screws, no drilling. Fits 1–2 power cables (Ø7.5 mm) and 1–3 network cables (Ø4 mm), the cables slide freely.
You need: 2× neodymium magnet Ø10×2 mm, a drop of super glue.
Print: PETG, as provided (already oriented), no supports. Print the test slice first to check the fit.
Assembly: Press the magnets in from below, secure with glue, place the clip over the cables.
The FreeCAD file is parametric (length, channel size, magnet size, clearance).
Not affiliated with LINAK A/S.
---
🇩🇪 Deutsch
Flache Kabelklammer für den Stahlfuß eines LINAK Desk Frame 2. Hält mit zwei Magneten – ohne Schrauben, ohne Bohren. Passt für 1–2 Kaltgerätekabel (Ø7,5 mm) und 1–3 Netzwerkkabel (Ø4 mm), die Kabel gleiten frei.
Benötigt: 2× Neodym-Magnet Ø10×2 mm, ein Tropfen Sekundenkleber.
Druck: PETG, so wie geliefert (bereits ausgerichtet), ohne Support. Zuerst das Testslice drucken und die Passung prüfen.
Montage: Magnete von unten eindrücken, mit Kleber sichern, Klammer über die Kabel setzen.
Die FreeCAD-Datei ist parametrisch (Länge, Kanalgröße, Magnetgröße, Spiel).
Kein offizielles Zubehör von LINAK A/S.