Tronxy X5S mgn12 overhaul
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Kinematics for X5S printers, for use with MGN12 linear rails, dragon hotend, and sherpa mini or orbiter 1.5 extruders
- Ocena
- 0 / 5
- Polubienia
- 13
- Pobrania
- 45
- Wydruki
- 0
- Wyświetlenia
- 986
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Printer Parts & Upgrades
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
This is a full kinematics overhaul for the Tronxy X5S and X5SA series printers. I have tested all these parts together, and have had clean prints at up to 120mm/s with PETG.
It requires 3 mgn12 linear rails, the length of which will depend on the model of printer you are upgrading, but the standard X5S model will require 2 x 450mm and 1 x 470mm.
The original belt idlers will not fit, so a total of 8 pulleys with a 5mm bore are needed, 6 with 20 teeth, 2 smooth.
The motor towers and Idler towers are remixed from another set I have had for a long time and cannot find the original upload. I did not make these, only adjusted them to match the set. The Y carriages are also remixed, but from another different set of parts for which I don't know the original source.
I advise printing these in ABS, Nylon or Polycarbonate. PETG is possible but not ideal.
Edit 16/05/22: Added Volcano heatblock compatible X carriage
Edit 18/05/22: Volcano version should be compatible with the new Rapido hotend in HF form, UHF not yet supported.