Tronxy X5S mgn12 overhaul
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Kinematics for X5S printers, for use with MGN12 linear rails, dragon hotend, and sherpa mini or orbiter 1.5 extruders
- Rating
- 0 / 5
- Likes
- 13
- Downloads
- 45
- Makes
- 0
- Views
- 986
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Other Printer Parts & Upgrades
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
This is a full kinematics overhaul for the Tronxy X5S and X5SA series printers. I have tested all these parts together, and have had clean prints at up to 120mm/s with PETG.
It requires 3 mgn12 linear rails, the length of which will depend on the model of printer you are upgrading, but the standard X5S model will require 2 x 450mm and 1 x 470mm.
The original belt idlers will not fit, so a total of 8 pulleys with a 5mm bore are needed, 6 with 20 teeth, 2 smooth.
The motor towers and Idler towers are remixed from another set I have had for a long time and cannot find the original upload. I did not make these, only adjusted them to match the set. The Y carriages are also remixed, but from another different set of parts for which I don't know the original source.
I advise printing these in ABS, Nylon or Polycarbonate. PETG is possible but not ideal.
Edit 16/05/22: Added Volcano heatblock compatible X carriage
Edit 18/05/22: Volcano version should be compatible with the new Rapido hotend in HF form, UHF not yet supported.