Adjustable leg end for tables
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Cover and floor protection for screws used prolongation of table legs - fits to screws M10.
- Ocena
- 0 / 5
- Polubienia
- 4
- Pobrania
- 18
- Wydruki
- 0
- Wyświetlenia
- 297
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Office
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
Print the model four times, it is better to print two legs at once, it is faster. The leg ends are meant to be used with metal legs of 30mm diametter and ordinary screws M10. The screw may be as long as you need from 20mm to 80mm. If you plan to use shorte screws, you can simply stop printing earlier, but if the cover is longer, it doesn't matter.
There is a small cap that can be used for fixin the screw inside of the cover. Put the cap on the screw as is showed on the cover photo, then push the cover on screw and start to scre until it is tightly screwed then simply unscrew the whole part do the desired position.
Print at 0,3mm per layer 20% of fill.