1 / 3
Dust Port Adapter - Sawstop Table Saw to 50mm Festool Hose — zdjęcie 1
1 / 3

Dust Port Adapter - Sawstop Table Saw to 50mm Festool Hose

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Off the shelf dust port adapters stick out too far, especially for Sawstop PCS/ICS Table Saws with mobile bases

Ocena
5 / 5
Polubienia
18
Pobrania
85
Wydruki
1
Wyświetlenia
1666
Oceny
1

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Other Ideas
Licencja
Creative Commons — Attribution — Noncommercial — Share Alike

Background

I use an old Festool CT-22 vacuum + Oneida Dust Deputy cyclone separator with my Sawstop PCS and it works well! This lets me avoid having to buy a bulky dust collector and route 4" duct work around my small workshop. I'm sure the newer CT-26/36/48 dust extractors would work even better. 

Description

Dust Port Adapter for Sawstop Cabinet Table Saw 3-7/8" to Festool 50mm (452896) Anti-Static Hose. Both ends of the adapter are tapered for tight fits; see the cross-section animation below for revolve profile and dimensions. Furthermore, on the 4" (nominal) side, there are reliefs cut every 90° and a small pocket that allows for a hose clamp to tightly clinch around the Sawstop dust port. 

Settings

Prints much faster if larger nozzle size is used! Print time is 1 hr 45 min with 100% infill, a 1.0mm nozzle, and variable layer height. I used PETG.

Rules

  • Please abide by the license and do not print these for commercial use. 
  • Please do not sell these for profit.
  • Please leave a tip if you find it useful.
  • Please reach out to me if you'd like me to print one for you.

Tagi