Permanent connection (Festanschluss) Oase InScenio 230
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Adapter to connect/terminate cables permanently on a Oase InScenio 230 outdoor power outlet.
- Ocena
- 0 / 5
- Polubienia
- 0
- Pobrania
- 9
- Wydruki
- 0
- Wyświetlenia
- 537
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Outdoor & Garden
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
I created this model to replace the power socket on an Oase InScenio 230 with a permanent connection instead of an extension cord.
Main reason was, that I have several of these in serial, all connected to a 5x2.5mm² line and I wanted to be able to control the 4 sockets per outlet independently.
By using the 5-wire cable, I can connect the individual sockets to three different groups and switch them via KNX relays in my garage.
- Dimensions are for 5x2.5mm² underground cable (Erdkabel). Tight fit, you might have to cut a small bevel into the edge of the isolation of the cable for easier insertion.
- The two-hole version is for looping the connection through to a next one in line
- The one-hole version is for the last outlet in the line
- Only use if you know what you are doing and/or let have it installed by a professional.
- So far, I have not found a way to remove the pre-installed plug without destroying it. Just open the outlet and cut off the retaining ring-clip-thingy.
(German)
Ich habe diese einfachen Teile konstruiert, um Oase InScenio 230 Außenverteiler fest an eine 5-adrige Leitung anzuschließen, anstatt über ein Verlängerungskabel.
Der Hauptgrund dafür war, dass ich mehrere davon in Reihe anschließen wollte und die Dosen in den Verteilern einzeln schalten wollte.
Mit einem 5-adrigen Erdkabel kann man die je 4 Dosen pro Verteiler auf 3 verschiedene Gruppen aufteilen.
- Die Öffnungen sind für 5x2.5mm² Erdkabel ausgelegt. Ggf. muss die Isolation etwas schräg angeschnitten werden damit das Kabel sich einführen lässt.
- Die 2-Loch Version ist zum Durchschleifen des Kabels an einen weiteren Verteiler gedacht.
- Die 1-Loch Version ist für den letzten Verteiler in der Reihe, bzw. einzelne Verteiler gedacht.
- Bitte nur einbauen, wenn ihr wirklich wisst was ihr da tut. Ansonsten bitte von einem Fachmann anschließen lassen!
- Ich habe bisher keine Möglichkeit gefunden, den vorinstallierten Stecker am Verteiler zerstörungsfrei zu entfernen. Man muss den Verteiler öffnen und den umlaufenden “Clip” abschneiden.