Phone stand with reversible charge cable
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A phone stand for both Android and iPhone (Tablets should work, but might be a bit wobbly!
- Ocena
- 4,4 / 5
- Polubienia
- 95
- Pobrania
- 1060
- Wydruki
- 4
- Wyświetlenia
- 3157
- Oceny
- 5
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Portable Devices
- Licencja
- Creative Commons — Attribution
A phone stand for both Android and iPhone (Tablets should work, but might be a bit wobbly!), that has an integrated slot under the phone for a charging cable.
You can reverse the positioning of the cable so that it is the correct orientation for your device (Android micro USB users).
The hole for the cable is a little larger than a typical cable. I have tried a few and it fitted, but if yours does not fit you could either sand/file down the inside, edit the attached SolidWorks model for your specific cable, or use something like a soldering iron to slightly (and carefully!) enlarge the hole.
Print instructions
Category: Mobile Phone Print Settings
Printer: Craftbot Plus
Rafts: No
Supports: Yes
Resolution: 0.3mm
Infill: 25%
Notes:
REMEMBER TO ROTATE ON ITS SIDE
So that it doesn't need to use loads of support.
How I Designed This
SolidWorks Design
Uploaded is the SolidWorks model I created for this object. Within it you should be able to see the steps I took to create this model.