Surface Mount for the Ethernet Clip
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
An accessory Surface Mount for Ethernet Clip by Rob
- Ocena
- 5 / 5
- Polubienia
- 8
- Pobrania
- 49
- Wydruki
- 1
- Wyświetlenia
- 406
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Computers
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
An accessory mounts for 2-, 3- or 4-cable Ethernet Clips designed by Rob (https://www.printables.com/pl/model/71262).
To be stable, clip have to be tight fitted, so I made an additional placeholder which you can place instead of a cable.
Mount has a flat surface so you can use double-sided tape. However, if you want to use a screw, there is a prepared area that you can pierce.
Checked with a 2,5 and 3,5 mm countersunk screws.
The models have been arranged in the position that gives the best effect (IMHO).
I print them with PLA on glass cleaned with IPA, without any adhesion improving agents, without support or brim. 0.4 mm nozzle, layer 0.2 mm, 100% infill because I want to be sure that the printed elements will be useful even if there are printing mistakes.
(I did not mark the model as a remix of Rob's Ethernet Clips because it is an addition to an existing model, not a modification)