1 / 2
ADXL FLSUN SR and v400 superracer large board and for v400. Trianglelab — zdjęcie 1
1 / 2

ADXL FLSUN SR and v400 superracer large board and for v400. Trianglelab

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Re-mix for ADXL with usb included from trianglelbas

Ocena
0 / 5
Polubienia
11
Pobrania
86
Wydruki
0
Wyświetlenia
1444
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Licencja
Creative Commons — Attribution — Share Alike

 

A modification for triangle lab adxl (larger board with usbC connector).  link.

FOR SR:

Modified to be mounted permanently. Leveling switch is not obstructed and sink fan exit is mostly free of obstructions.

BlownUp: thanks for preventing a waste of equipment.

For this mount you will need:

  • 4 M2x8mm screws to connect the ADXL and the outer piece of the mount
  • 1 M3x8mm screw to secure the mount in place
  • 1 M3 hex nut, for securing the mount in place

For V400:

2 m3x20mm.

2 m3 hexnuts.

4 shoth 2mm screws

Remove the screw that is holding the extruder plastic frame.

Remove the fame

Put a nut on the frame *Where the previous screw was)

On the printed mount put the middle screw and pass it throu the oval opening just below.

Put the hexnut to fix the second screw(leave some space)

Put the frame back to position. put the second screw through the upper hole it will fix the frame and the mount.

Put the adxl and 4 short screws of 2mm

Tagi