Sous Vide Immersion Circulator Wall Bracket
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
I got a Monoprice Strata Sous Vide immersion circulator, but don't have any good place to keep it and wanted it handy…
- Ocena
- 0 / 5
- Polubienia
- 5
- Pobrania
- 20
- Wydruki
- 0
- Wyświetlenia
- 352
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Kitchen
- Licencja
- Creative Commons — Attribution
I got a Monoprice Strata Sous Vide immersion circulator, but don't have any good place to keep it and wanted it handy as I find I'm using it a bunch, so I made this bracket for it. The screw holes are sized for #8 screws. On the right is a ledge for hanging the clamp and on the left is cord storage. This should also fit the Anova circulators and maybe others that are 65mm in diameter or less.
Note: It is not a snug fit, but I just want it to hold, not struggle to get it in and out. you can probably add a piece of foam weather stripping or something if you want a tighter fit. I also ran it through Meshmixer and added my own supports for the power cord stanchion because the Slic3r support generator was just about useless. The screw holes should accept #8 screws, but will require a little persuasion or an appropriate drill bit as I made the tolerances a little tight.
Print Settings
Printer Brand:
Prusa
Printer:
Prusa Mk2
Rafts:
No
Supports:
No
Resolution:
.3 mm Layer height
Infill:
20%
Filament: Don't Remember PLA Gold
Notes:
I added supports via MeshMixer, so this should be able to be printed with supports off in the slicer
Category: Kitchen & Dining