INGCO 20V Tool - Workshop Holders / Brackets
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
INGCO P20S 20V Tool bracket for hanging tools upside down under a shelf
- Ocena
- 5 / 5
- Polubienia
- 35
- Pobrania
- 526
- Wydruki
- 0
- Wyświetlenia
- 2171
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Tools
- Licencja
- Creative Commons — Attribution
Updated model here: https://www.printables.com/model/308083-ingco-20v-tool-workshop-holders-brackets-v2
INGCO 20V (P20S) power tool bracket / mount, for holding/hanging your tools in your workshop space.
Can be mounted upside down (hanging) and slide the tools on to the holders.
4 countersunk screw locations for screwing the mount to (or under) your shelf / bench.
Holders use the battery location, so the tools are mounted with the batteries removed.
Tested with Drill, Impact Driver, Impact Wrench, Jig Saw, and Torch, so should work with most if not all available INGCO 20V P20S tools.
For the prototype prints shown I have just printed this with Sunlu PLA+, and Bambu Basic PLA, on my Bambu Labs X1C printer, printed on Textured PEI bed.
Supports are required just for the overhang where the tool slides in, very easy to remove and came off clean in my case.
15-25% infill should be totally fine, these were printed with 20%, 4 walls, 4 top/bottom layers - for a bit more strength.