Ender 3 | Dual 5015 Fan Duct
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Simple minimalistic fan duct for Ender 3 3D printers.
- Ocena
- 5 / 5
- Polubienia
- 92
- Pobrania
- 791
- Wydruki
- 5
- Wyświetlenia
- 5451
- Oceny
- 6
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Creality Parts & Upgrades
- Licencja
- Creative Commons — Attribution
Overview
This is a simple, one piece, minimalistic, and high perfomance Fan duct for Ender 3 or printers with same x-gantry plate. It is highly inspired by ammaryasir's remix of Satsana fan duct. It is also compatible with SpeedDrive (3D Printed Direct Drive).
Printing
To print this put it on it's flat side (back), 0.20mm layer hight is good enough and don't take too long, for infill use 30% or higher. If your printer have really bad bridging performance use supports, build plate only and 85 overhang. It will take about 8 hours and 45 minutes and about 70 grams of PLA.
Installation
To Install this fan duct you only need 2 M3 screws that are already holding the original fan shroud and for the hotend (4010) fan you can use original screws too but for 5015 fans you either don't use screws at all (the fans are perfect fit so they are holding them selfs) or 25x4M screw.
You should be done at this point and you can peacefully enjoy this Fan Duct!
Right orientation of the part:
Printing Process:
On Printer:
Cooling Performance
In this video I am going from 20% to 1OO% of Fan speed.