Wireless Charging Stand
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Custom wireless charging phone stand This charger needs some electronics, you can buy this from Ali Express: Qi…
- Ocena
- 0 / 5
- Polubienia
- 5
- Pobrania
- 32
- Wydruki
- 0
- Wyświetlenia
- 505
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Portable Devices
- Licencja
- Creative Commons — Attribution
Custom wireless charging phone stand
This charger needs some electronics, you can buy this from Ali Express:
Qi Wireless Charger PCBA Circuit Board
And you need to do some soldering. See images for visual instructions.
You can make the stand custom made for you phone. Measure the width and height of you phone, including the phone case. Then, open the Customizer and enter the width and height in millimeters and click the Create Thing button.
Print the lid with transparent filament, if you have that.
Print Settings
Rafts:
No
Supports:
No
Post-Printing
Required:
- Wire
- Qi Wireless Charger PCBA Circuit Board
- Soldering iron and solder
- Heat shrink tubing or other insulation material like adhesive tape
- Glue suitable for plastic
Cut and strip two wires of about 42mm (1.6 inch) long.
Solder the wires between the coil and the green PCB.
Add glue on the coil and glue it to the stand. Be carefull when applying pressuree: the grey disk is fragile and can break easily. But it will still function with a crack.
Insert the PCB with the USB-connector first.
Use a screwdriver or something similar to press the wires in the slit.
Insert the lid.
Category: Mobile Phone