IKEA Kallax Lightstrip Mounts & Corner Decor
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Elements to mount lightstrips up to your IKEA Kallax or hang something from the edge. Prints in vase mode!
- Ocena
- 0 / 5
- Polubienia
- 22
- Pobrania
- 46
- Wydruki
- 0
- Wyświetlenia
- 800
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Living Room
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
Corner and edge element to mount lightstrips up to your Ikea Kallax or hang something from the edge. We used this to hang a lichtstrip across two Kallax shelfs. You can also use it as deco element.
The hook or loop has an inner diameter of about 2mm, but the cutout is about 1mm wide. So you may barely fit two 1mm cables into the hook one after the other, but it was mainly designed to hold one cable securely without it dropping out, but also leave some room to adjust the cable once it's in there.
Printing
All pieces print in vase mode in all variants (left and right corner and edge piece). Make sure to set your bottom layers to that the hole diagonal section prints as a solid layer but not more than that. All walls are 1mm thick, so either increase the outer perimeter thickness to at least 0.5mm (or exactly 0.5mm without the archne generator) or leave it at the default for 0.4mm nozzles if your printer is known to overextrude a bit. The chamfer on the top edge should prevent an open top, even if the walls have a slight gap between them.
I went with 0.2mm layers which came out very good. Of course values from 0.1 to 0.3mm will also work fine in my opinion. Printing time was about an hour each with more or less stock ender 3 settings with these parameters.
I would highly advice to use vase mode for this, as is generally makes a nicer finish (especially with thin parts/walls) and increases the parts strength in z-direction. But normal slicing and printing is of course also possible if you don't want to print these one after the other.
After printing
To fix the elements to the shelf simply use double sided tape. I used to pieces of tape for each element (on two separate inner walls) to get a secure mount with the possibility to have it wiggle loose after some time.
If you want a less subtle look I also included a piece with no hook. This can be fixed along with the hook-pieces to highlight your Kallax shelfs in a different colour on the corners. This is also an option if you don't have the matching colour filament for your shelf at hand.
Happy Printing :)