Lian Li O11 XL - 120mm Fan Duct
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
120mm fan duct for the right side of the Lian Li O11 XL
- Ocena
- 5 / 5
- Polubienia
- 100
- Pobrania
- 713
- Wydruki
- 6
- Wyświetlenia
- 4456
- Oceny
- 6
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Computers
- Licencja
- Creative Commons — Attribution — Noncommercial
On the right side of the Lian Li 011 XL, there is a spot for 3x 120mm fans. After initially assembling, I noticed that all of the wires ran through this location and blocked a lot of airflow. I created this fan duct to almost make contact with the right side panel, allowing for the wires to route around the duct and for airflow to be uninhibited. Note: it does not make contact with the side panel but it is very, very close. I did not do a before an after on temps inside the case as I did this while I was building it.
I used screws that came with the case. Nothing special. STEP file included if anyone would like to make changes.
Recommended print settings:
- 0.6mm nozzle, 3x+ perimeters
- PLA/PETG
EDIT 12/28/2022: Just realized that this wasn't an original idea and have changed the post as such. I posted two designs that I probably had inspiration from. I originally designed this 01/21.