Modified Servo Wiper Arm (REMIX) for Enclosed VCORE3
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
This is a remix of LumberjackEngineering's servo deployed Nozzle wiper.
- Ocena
- 0 / 5
- Polubienia
- 4
- Pobrania
- 24
- Wydruki
- 0
- Wyświetlenia
- 354
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Ideas
- Licencja
- Creative Commons — Attribution
This is a remix of LumberjackEngineering's servo deployed Nozzle wiper. With an enclosure on the vcore3 I couldn't fit the servo deployed nozzle wiper for 3030 extrusion anywhere without having interference with the bed, extruder assembly or x axis even with stowed. So I modified the wiper arm and added a double bend to raise the brush up 40mm. This allowed me to mount the rest of the assembly lower and provide the clearance necessary on my printer. I mounted mine on the left rear vertical 3030 (below and left of the y axis end stop) below the corner bracket (about 8mm between the bottom of the bracket and top of the designed mount).
Print Settings
Printer:
Ratrig VCORE3 500
Rafts:
No
Supports:
Yes
Resolution:
.2
Infill:
35%
Filament:
Any ABS, ASA
Any
Notes:
I print this on it's side and chop off a small portion of the round servo attachment by placing it below the bed so the rest of the part is flat on the bed surface. I add supports for the cylinder and the brush holder opening.
Category: 3D Printing