80mm Fan Holder for TP-Link TL-SX105
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Snap-on bracket for an 80mm fan onto the TP-Link TL-SX105 10gbe switch to help with overheating
- Ocena
- 0 / 5
- Polubienia
- 3
- Pobrania
- 51
- Wydruki
- 0
- Wyświetlenia
- 1160
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Computers
- Licencja
- Creative Commons — Attribution
The TP-Link TL-SX105 10GBE switches are prone to getting very hot when under load. I designed this bracket to hold an 80mm fan on the top surface for cooling.
The bracket snaps onto the venting holes on the side, occupying 3 on each side but leaving the others exposed. This way the bottom stays flush for screw mounting. Air is drawn in from the fan and pushed over most of the switch's surface before being exhausted out of 4 holes. In my tests with a Noctua NF-A8, temperatures went down by about 15C.
Printed in PETG. PLA not recommended due to warping under heat.
If you go with the STL, slice the model at 35mm for easier printing and then connect the parts with 6 M3 screws. The bottom of the vent has inserts for the screw heads to disappear into.