Ender 3 Pro 100mm Lack Extensions

Wanted to build an Ikea Lack enclosure for my modded Ender 3 Pro. 

However I wanted to use some thick plexiglass I had laying around to save $. 

Also wanted the plexiglass recessed in a bit so I could trim it out with 3D printed quarter round. You can adjust in tinker cad to fit the thickness you want for you'r plexiglass.

.

I have constant drafts in my workspace, and temperature fluctuations as much as 15-20 degrees. This makes printing with certain filaments near impossible. After building a cheap enclosure I decided to make something that looks nice. Big thanks to everyone that has already made these as that's where all the inspiration came from.

.

Please post you'r makes, and rate my model. 

.

Before installing pre drill all holes to prevent splitting, and don't over tighten screws/nuts/bolts. I used plastic washers between plexiglass, and screw head, and between nuts, and 3D parts.

.

Printed in both PLA+, and PETG. Have a feeling I'll keep building on this design to incorporate Air Filtration, Wire routing ports, Filament Guides, Spool Holders, Tool Boxes, PSU mounts, Electronics mounts, Temp sensor/thermometer housing. Possibly thermostat controlled intake/exhaust, led mounts, etc. 

So if you want to see more let me know by smashing the like button, and posting makes.

.

Print settings PLA+/PETG

Infill Cubic 25% or more.

No supports Base down.

2-4 walls (2 walls saves about an hour but isn't as strong).

Bed/Nozzle temp depends on your setup.

Bed adhesion is crucial to get nice flat prints.