Ender 3 Pro 100mm Lack Extensions
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Bottom Extensions for Lack builds. Wanted to use 9.25mm thick lexan I had laying around, and wanted the lexan recessed.
- Rating
- 5 / 5
- Likes
- 11
- Downloads
- 54
- Makes
- 1
- Views
- 556
- Reviews
- 1
Updated at source:
Model information
- Source
- Printables
- Category
- Creality Parts & Upgrades
- License
- Creative Commons — Attribution — Noncommercial
Wanted to build an Ikea Lack enclosure for my modded Ender 3 Pro.
However I wanted to use some thick plexiglass I had laying around to save $.
Also wanted the plexiglass recessed in a bit so I could trim it out with 3D printed quarter round. You can adjust in tinker cad to fit the thickness you want for you'r plexiglass.
.
I have constant drafts in my workspace, and temperature fluctuations as much as 15-20 degrees. This makes printing with certain filaments near impossible. After building a cheap enclosure I decided to make something that looks nice. Big thanks to everyone that has already made these as that's where all the inspiration came from.
.
Please post you'r makes, and rate my model.
.
Before installing pre drill all holes to prevent splitting, and don't over tighten screws/nuts/bolts. I used plastic washers between plexiglass, and screw head, and between nuts, and 3D parts.
.
Printed in both PLA+, and PETG. Have a feeling I'll keep building on this design to incorporate Air Filtration, Wire routing ports, Filament Guides, Spool Holders, Tool Boxes, PSU mounts, Electronics mounts, Temp sensor/thermometer housing. Possibly thermostat controlled intake/exhaust, led mounts, etc.
So if you want to see more let me know by smashing the like button, and posting makes.
.
Print settings PLA+/PETG
Infill Cubic 25% or more.
No supports Base down.
2-4 walls (2 walls saves about an hour but isn't as strong).
Bed/Nozzle temp depends on your setup.
Bed adhesion is crucial to get nice flat prints.