Mini Satsana Ender 3 V2 Remix (Compatible with BL/CR touch)
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Mini Satsana hotend cover remixed to work with the Ender 3 V2
- Ocena
- 4,917 / 5
- Polubienia
- 53
- Pobrania
- 415
- Wydruki
- 12
- Wyświetlenia
- 2398
- Oceny
- 12
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Creality Parts & Upgrades
- Licencja
- Creative Commons — Attribution — Noncommercial
This is an older design of mine.
Compatible with the Ender 3 V2 and stock fans, or a 4020 Noctua
Works with or without bed probes
Printing:
The only thing that needs support is the overhang on the leftmost screw hole.
Use support blockers or turn “Touching buildplate” on.
Bed probe users print cover.stl and clip.stl
Manual bed levelers print cover.stl, clip.stl, and spacer.stl
Installation:
Requires 2-4 M2x6 and 6-8 M3x8 screws
(comments say that you can use stock screws but I have never tried it)
Variation is for if you want to attach your fans with either 2 or 4 screws.
Remove your bed probe bracket's bottom left screw if you have one.
Install the clip to the back of the cover using 2 M3 screws (Screws are very tight and may require lots of force)
Slide assembly down onto the plate from above (If you are struggling then you can remove the clip and re-install it with only the top screw after the cover is on)
Fasten the 2 M3 screws on the left side (If you don't have a bed probe then slide the spacer under the leftmost screw hole)
Install your fans using 2-4 M3 screws for the hotend fan, and 2-4 M2 screws for the blower fan.