Strengthened Cable support, EVA3 with 5015 fan parallel to back plate (remix)

On my Vcore3 500 the cable support on my eva3 hotend broke after only a couple dozen hours. It is a weak design because it has to make room for the 4028 fan or the dual 5015 fans that run perpendicular to the back plate in the stock EVA3 setup. I have no need for the 4028 or dual 5015 fans on my printer, it interferes with things on my printer, and imo it is overkill. So I used MCoSoNo's EVA 3 Inlet for 5015 fan parallel to backplate mod. This mod also allows me more room at Y=max end of the printer inside my enclosure. However, that mod uses the very weak stock EVA3 cable support print. So I took advantage of the additional room allowed from that mod to make the cable support larger and it will not fail, or let's say if it does you probably broke a bunch of other stuff on the hot end as well! I also changed the fan support (from the mod) slightly to use a 3mm heat set insert, which allows the 3mmx12 screw to engage more thread for a stronger connection. The heat set insert is for a 5.0546mm diameter hole, 3.8mm deep. If your 3mm insert is different, or if you want to make other changes, I also supply the step files for you to mod as you wish.