Replacement cap for van step floor screw
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
This is a 21 mm diameter cap that I designed and printed to replace ones that we lost while working on my sister's…
- Ocena
- 0 / 5
- Polubienia
- 3
- Pobrania
- 50
- Wydruki
- 0
- Wyświetlenia
- 398
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Automotive
- Licencja
- Creative Commons — Attribution
This is a 21 mm diameter cap that I designed and printed to replace ones that we lost while working on my sister's 2018 full size Transit van. I explored creating my own tessellation to mimic the textured pattern of the original cap. It worked out pretty well. The Transit van has a large plastic step at the sliding door opening. That step is held down by three or four screws that are then covered with these little pop-off caps.
Print instructions
Printer Brand: Prusa
Printer: I3 MK3S
Rafts: No
Supports: No
Resolution: 0.1 mm
Infill: 15%
Filament: Prusament PETG Black
Notes:
Inverting this in your slicer (pattern face-down) should allow you to print it with no supports. I think I even printed it right-side up without supports. Higher resolution yields better texture results, although the nature of the print is such that just about anything will look good in this application.