TP Link Omada EAP 6 Series (660,670) Wireless Access Point Mount Plate
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
This is a TP Link Omada EAP 6 Series (660,670) Wireless Access Point Mount Plate.
- Ocena
- 0 / 5
- Polubienia
- 13
- Pobrania
- 221
- Wydruki
- 0
- Wyświetlenia
- 1546
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Computers
- Licencja
- Creative Commons — Attribution — Share Alike
TP Link Omada EAP 6 Series (660,670,650,610) Wireless Access Point Mount Plate. This is a simple model to allow mounting of a TP Link access point if you either lost or dont have the original wall/ceiling plate for your EAP. I lost one of my ceiling mount plates and needed something fast so I drew this bad boy up. The one I am using I printed with 10% infill at .2mm quality with lightning infill via cura 5.2.1. I would avoid using a brim if you can as it will adhere quite well most likely as my first couple of prints did. Also keep in mind the accuracy of your printer the official plate is around 115mm across and this print is 116mm but I found with my Voxelab Aquila S2 this offered the right level of accuracy for a nice fit. I have found my Aquila to be +/- .25mm depending on the size of the print. Thank you all for downloading and I hope this helps someone.