8mm x 2mm Magnet DeWalt Bit Holder
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Very handy model I modified to fit my magnets.
- Ocena
- 5 / 5
- Polubienia
- 52
- Pobrania
- 283
- Wydruki
- 3
- Wyświetlenia
- 1413
- Oceny
- 3
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Tools
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
Great model by ucancallmebob89 on Thingiverse: https://www.thingiverse.com/thing:4419204
I only had 8mm x 2 mm round rare earth magnets, so with a bit of TinkerCAD time I was able come up with a mod to fit my needs. The use of built in supports where needed is quit a slick trick, good thinking Bob!
I went ahead and tried the magnets attached through the bottom so that I could easily enlarge the magnet holes if needed. The magnet holes are printed to exact size and after a very brief widening of the beginning lip with an over sized drill bit, the magnets slid in beautifully. Little bit of super glue and they ain't goin nowhere ;)
I never realized how often I could use an extra hand to hold a few screws until I installed this model!
This print fit my DCF787 Type 1 ¼" Impact Driver
Thanks again for the effort ucancalmebob89!