Dyson Accessory Holder V8 not Compatible with V10 (printable with the Mini)
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
The Dyson accessory holders - Doubled ( V8 and V7 and V10 ) from FCUK was too big for the Mini so I changed it a bit ;)
- Ocena
- 5 / 5
- Polubienia
- 25
- Pobrania
- 143
- Wydruki
- 1
- Wyświetlenia
- 1328
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other House Equipment
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
To put it together you need two M5 screws that are about 2cm long and two fitting hex nuts. They fit really tight so just screw in the screw and go on turning until the hex nut is getting pulled into the right space ;)
I change the clips as well. But they would not really hold so I heated the top part and bend it back a bit. A lighter was fine.. Just heating it up for like 3 seconds I think should work to bend it it backwards. Or try the clips from the original ;)
I needed supports for the Dyson_Halterung_1 and 2 ;)