Heatset Insert and CR Touch Remix - KP3S BMG V6 LMaker Direct Drive Toolhead
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Uses heat set inserts and has other modifications for durability. Toolhead Hotend and Extruder Mount for KP3S
- Ocena
- 0 / 5
- Polubienia
- 12
- Pobrania
- 66
- Wydruki
- 0
- Wyświetlenia
- 1337
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Printer Parts & Upgrades
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
I am looking to grow my new channels! Give me a follow on youtube and mastadon! and please feel free to say hello :)
https://www.youtube.com/@homegrown3dprint
https://mastodon.social/@homegrown3d
From Article https://www.homegrown3d.com/2023/02/22/kingroon-kp3s-3d-printer-review-and-upgrades/
Go to article to find editable tinkercad files (near the bottom of article, use table of contents for ease).
LMakers toolhead was the best I could find for a v6 hotend and bmg extruder.
Still found a few things that weren't to my taste.
Thickened up the BMG mount so it is more durable.
Extended the wire management area and made it a little easier for zipties.
Optimized printability of overhanging circles, with a tiny square that prints for one layer for better overhangs. Maybe could have done more work on this but it was good enough.
M3 Threaded Heat Set Inserts, I use these inserts https://amzn.to/3WDwYqw
I included a photo of the heat set insert dimensions if you want to source them from elsewhere.
Trimmed V6 mount so its more durable when removing the hotend.
Few other small changes here and there as well.
CR touch mount is a remix from a design from a website that is no longer active.