1 / 1
Sprite cable holder for Ender 3 belted Z mod
Zamów wydruk tego modelu
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Gets your Sprite's cable out of the way - no reprinted parts needed!
- Ocena
- 5 / 5
- Polubienia
- 24
- Pobrania
- 117
- Wydruki
- 1
- Wyświetlenia
- 1640
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Creality Parts & Upgrades
- Licencja
- Creative Commons — Attribution
SzczegółyPliki (4)Wydruki i komentarze (Wydruki: 1) (Komentarze: 1)Remiksy (1)Kolekcje (40)Powiązane
Printing: print at 100% infill (seriously) in PETG, ABS, or similar (no PLA)
Model selection: there are two models included - one that fits over the existing belt retainer and another that replaces it entirely. NOTE: I have not tested the full-replacement model whatsoever and it may or may not work. If you print it, please let me know how it goes!
Installation Notes:
- The attachment point is 2mm thick, so swap out your existing belt retainer bolts with something 2mm longer (I used M3x14)
- The model has holes for an Allen key to go through to allow for tightening
- You need to loosen your belt tension on the one side almost fully. If you're careful, you can install this one side at a time without having the belt move from its original position
- After installation, slip in your extruder cable and cinch it down with some zip ties
Changelog:
- V1:
- Initial release!
- V2 (2022-02-22):
- Thickened beam supports
- Added fillet support between beam and holder
- Added model with belt retainer built in
- V3 (2022-02-23):
- Increased height of belt retainer so the top will align with the top of the original - makes visual alignment easier
- Increased height of belt retainer so the top will align with the top of the original - makes visual alignment easier