1 / 1
Sprite cable holder for Ender 3 belted Z mod
Order a print of this model
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Gets your Sprite's cable out of the way - no reprinted parts needed!
- Rating
- 5 / 5
- Likes
- 24
- Downloads
- 117
- Makes
- 1
- Views
- 1,638
- Reviews
- 1
Updated at source:
Model information
- Source
- Printables
- Category
- Creality Parts & Upgrades
- License
- Creative Commons — Attribution
Printing: print at 100% infill (seriously) in PETG, ABS, or similar (no PLA)
Model selection: there are two models included - one that fits over the existing belt retainer and another that replaces it entirely. NOTE: I have not tested the full-replacement model whatsoever and it may or may not work. If you print it, please let me know how it goes!
Installation Notes:
- The attachment point is 2mm thick, so swap out your existing belt retainer bolts with something 2mm longer (I used M3x14)
- The model has holes for an Allen key to go through to allow for tightening
- You need to loosen your belt tension on the one side almost fully. If you're careful, you can install this one side at a time without having the belt move from its original position
- After installation, slip in your extruder cable and cinch it down with some zip ties
Changelog:
- V1:
- Initial release!
- V2 (2022-02-22):
- Thickened beam supports
- Added fillet support between beam and holder
- Added model with belt retainer built in
- V3 (2022-02-23):
- Increased height of belt retainer so the top will align with the top of the original - makes visual alignment easier
- Increased height of belt retainer so the top will align with the top of the original - makes visual alignment easier