Superior SpafilClip, filament clip
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
SpafilClip, the (IMHO) best and only 1.75mm filament clip you need.
- Ocena
- 5 / 5
- Polubienia
- 10
- Pobrania
- 54
- Wydruki
- 2
- Wyświetlenia
- 320
- Oceny
- 2
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Accessories
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
SpafilClip, the (IMHO) best and only 1.75mm filament clip you need.
I prefer the self locking clips as they are not dependent on fitting a certain spool model. The downside is that they slip, or they put stresses on the filament causing it to bend or even break after a while.
The solution, straight groves printed with fuzzy skin!
Just push it through the hole, once around the spool and lock it in the straight groove.
A SpafilClip uses 1.2 grams (0.39 meters) of filament and prints in 3.35 minutes on my Bambu Lab x1c, and should print in under 8 minutes on an Ender 3.
I have included STL files for a single SpafilClip as well as for a 6 pack.
There are also .gcode files optimized for an Ender 3 or similar bedslinger.
If you like it or even make one, please post it, like, share, and consider a Paypal donation. Thank you!
Required setting: Fuzzy skin!
Recommendet settings:
- Material: Whatever you have laying around
- Layer height: 0.2 mm
- Infill: 15%
- Perimeters: 2
- Supports : No