Superior SpafilClip, filament clip
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
SpafilClip, the (IMHO) best and only 1.75mm filament clip you need.
- Rating
- 5 / 5
- Likes
- 10
- Downloads
- 54
- Makes
- 2
- Views
- 320
- Reviews
- 2
Updated at source:
Model information
- Source
- Printables
- Category
- Accessories
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
SpafilClip, the (IMHO) best and only 1.75mm filament clip you need.
I prefer the self locking clips as they are not dependent on fitting a certain spool model. The downside is that they slip, or they put stresses on the filament causing it to bend or even break after a while.
The solution, straight groves printed with fuzzy skin!
Just push it through the hole, once around the spool and lock it in the straight groove.
A SpafilClip uses 1.2 grams (0.39 meters) of filament and prints in 3.35 minutes on my Bambu Lab x1c, and should print in under 8 minutes on an Ender 3.
I have included STL files for a single SpafilClip as well as for a 6 pack.
There are also .gcode files optimized for an Ender 3 or similar bedslinger.
If you like it or even make one, please post it, like, share, and consider a Paypal donation. Thank you!
Required setting: Fuzzy skin!
Recommendet settings:
- Material: Whatever you have laying around
- Layer height: 0.2 mm
- Infill: 15%
- Perimeters: 2
- Supports : No