UM2 Cross Slider Block for 8mm linear rods
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
This slide block was design to be use with 8mm rods.
- Ocena
- 0 / 5
- Polubienia
- 6
- Pobrania
- 53
- Wydruki
- 0
- Wyświetlenia
- 607
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Printer Parts & Upgrades
- Licencja
- Creative Commons — Attribution
This slide block was design to be use with 8mm rods.
Material that you will need:
2x M2.5 screw + nuts ( 12mm )
2x M3 screw + nuts ( 10mm )
1x M3 screw + nut ( 12mm ) - This one i did use to lock the linear rod.
Original bearing ( ID8mm OD11mm x 30mm )
I did design this parts to be printed without supports.
I do not have an ultimaker so i did not test the parts, if you print this parts pls let me know if they work as is intended.
Print instructions
Category: 3D Printer Parts Summary
This slide block was design to be use with 8mm rods.
Material that you will need:
2x M2.5 screw + nuts ( 12mm )
2x M3 screw + nuts ( 10mm )
1x M3 screw + nut ( 12mm ) - This one i did use to lock the linear rod.
Original bearing ( ID8mm OD11mm x 30mm )
I did design this parts to be printed without supports.
I do not have an ultimaker so i did not test the parts, if you print this parts pls let me know if they work as is intended.