Ender 3 Raspberry PI 4B with 5" Touchscreen Case
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Case to mount a Raspberry Pi4B + 5" touchscreen to the left front of Ender 3 (NOT V2!)
- Ocena
- 0 / 5
- Polubienia
- 6
- Pobrania
- 31
- Wydruki
- 0
- Wyświetlenia
- 697
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Creality Parts & Upgrades
- Licencja
- Creative Commons — Attribution — Share Alike
This case is designed to fit an Raspberry 4B with a 5" Touchcreen to the left front edge of the original Ender 3 - not V2 or other variants!
It will be screwed into the two original holes on top of the electronic case. Moreover there is a an additional plate with a fan shroud to have a aesthetic appearance.
Requirements :
Touchscreen has the following dimensions and includes the HDMI and USB connectors. My one was from a company called “Elecrow”.
The screws of Y-Axis should be assembled like below. The nut has to be on the upper side to have enough clearance.
You will need an USB type C cable with a 90 degree connection, otherwise it wont fit to the metal frame. Route the cable through the hole in the backside of case and shroud.
Needed materials :
- 2x M3x16mm screw → to fix the case to the Ender3
- 4010 5V fan (optional)
- 4x M3x12mm screws (optional)
- 4x M3 Nut (optional)
- 4x M4x6mm screw → to fix the bottom plate
- 4x M3x5mm screw → to fix the display to the case
- 2x M3x8mm screw → to fix the fan shroud