X-Shot Chaos Meteor RXB-0060 Speedloader

I noticed a unused sliding lock at the base of the magazine. Maybe it was intended for a speedloader, but Zuru but never released to the market. So I made my own speedloader.

I printed this on my modified Ender 3 v2 with the following settings:

• Filament: eSun PLA+
• Layer height: 0.2mm
• Perimeters: 4
• Infill: 10% rectilinear
• Supports: No

Warning: The speedloader has a length of 23cm!

Assembly:

1. Print all parts.
2. Place the plunger with the pointy bit down into the speedloader tube, and slide it all the way down.
3. Put some glue in the slots of the endcap and place it on the open end of the speedloader tube.
   Make sure that that the plunger stays down as shown in the last picture, and away from the endcap, while the glue is drying!

Make sure you prime the magazine spring first before you load the balls with the speedloader.

The sliding lock doesn't really lock the speedloader in place, because Zuru designed it with a very flat surface. Make sure you do not keep the speedloader attached, as it will fall out eventually.

Any feedback is welcome, so please leave a like or make if you think this is awesome.