RJ45 Dust Cover Flexible Version Without Handle
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
I adapted the RJ45 Dust Cover by BradleyB for use with a mobile device and flexible filament
- Ocena
- 5 / 5
- Polubienia
- 17
- Pobrania
- 120
- Wydruki
- 1
- Wyświetlenia
- 784
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Computers
- Licencja
- Creative Commons — Attribution — Share Alike
About
I made this for my ZTE MU5001 Mobile router, its RJ45 port is awesome but id guess it quickly gets full of lint and other stuff if i just throw it into my backpack.
Only editing happened in PrusaSlicer, by adding a negative volume and flipping it 180 i simultaneusly removed the handle that is inconvenient on a mobile device, and made it more printable with flex filament due to no overhangs.
Settings
Printed using Prusa i3 MK3S on the textured spring steel sheet with extrudr Flex Semisoft (85A) Transparent with these settings:
Layer Height: 0.2mm
Infill: Gyroid
Infill Density: 40%
There is an official Prusa profile for the material used, but i used an older one adapted on DAS FILAMENT TPU, which uses 2mm retracts.
I scaled it up 105% as the first attempt fell out of the port.
Material with a shore hardness of 95A likely works just as well but i haven't tried it.
License
Attribution-ShareAlike 4.0 International (CC BY-SA 4.0)
- Free to modify and republish with credits and the same license
- Applies to photos as well
- Optional: If this was of use to you or if you made something based on it please tell me about it!