Extrusion brace connector 45 degree
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Made this for my work bench to give some stability to the backboard.
- Ocena
- 0 / 5
- Polubienia
- 6
- Pobrania
- 38
- Wydruki
- 0
- Wyświetlenia
- 190
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Mechanical Parts
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
Made this for my work bench to give some stability to the backboard, after mounting the backboard is pretty sturdy, Im sure there are other uses for this adapter hence why I am sharing.
There are 2 models one is mirrored from the other if like me you need one at each end.
I printed this in PLA, I will probably do it again in PETG at some point.
I used Gyroid infill 30%, 0.2mm layer height, no supports, no adhesion, print the model with the set orientation it should be ok.
This was made to fit with 0.6mm tolerance to ensure a snug fit, I did have to lightly tap one of the models with a mallet (wrapped in a cloth) to get it all of the way down.
I used M5 x 8mm machine screws and T-nuts (2 on each model) to secure the bracket to the extrusion, but if you are using this the same way I am you wont need them , once mounted they aren't going to slide off.