MacBook charger protection

🇬🇧 – English – 

This protection is for MagSafe MacBooks for (mostly) European charger types.

Unfortunately, my chargers from Apple bend very easily and a while ago it got to a critical point when I unpacked my stuff on a business trip and the charger was completely bent. I had to create a protection for the charger.

The ‘cap’ has two versions - with and without a MagSafe holder. 

Since the charger can differ in size by a few decimals of millimetres, I recommend doing a test print first (test.stl) to check how firm it holds or if it's not too loose. If it's too loose, adjust the Scale factors from 100% to 99.9% and try again.

I tested the version without it on a MacBook USB-C charger (Intel versions) and it's a bit loose, so I would recommend printing it with approx 99.9% scale.

🇨🇿 – Czech – 

Vymodelovala jsem ochranu pro MagSafe MacBooky pro ceske zasuvky.

Bohuzel se mi casto stava, ze se mi nabijecka na MacBook ohne a pred nedavnem uz to dosahlo vrcholu, kdy jsem na byznys ceste vybalila veci a nalezla nabijecku v batohu uplne ohnutou, takze jsem si musela vyrobit vicko.

Vicko ma dve verze - s MagSafe drzackem a bez neho.

Protoze se nabijecky mohou o par desetin milimetru lisit, doporucuju nejdriv udelat testovaci tisk (test.stl), aby se zjistilo, jak dobre na nabijecce bude drzet. Pokud by to bylo az moc volne, v PrusaSliceru bych zkusila zmenit Slice faktors z 100% na 99.9% a udelala dalsi testovaci tisk.

Viko jsem otestovala i na MacBook USB-C nabijecce (ty s Intelem) a byla trosku volna, takze tam bych rovnou sla minimalne do 99.9% pomeru vuci puvodni velikosti.