1 / 2
Gates for Seimitsu LS-5X/6X joysticks
Zamów wydruk tego modelu
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Restrictor gates that fit the LS-5X/6X line of Seimitsu Joysticks
- Ocena
- 0 / 5
- Polubienia
- 5
- Pobrania
- 55
- Wydruki
- 0
- Wyświetlenia
- 581
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Video Games
- Licencja
- Creative Commons — Attribution — Noncommercial — NoDerivatives
3D printable gates that will fit these Seimitsu joysticks:
- LS-33
- LS-55
- LS-56
- LS-58
- LS-60
- LS-62
- SEL-70 / SELS-70
Settings:
This model was designed with a 0.6mm nozzle and PETG in mind. Should print fine with 0.8 and smaller nozzles.
- Point your seam towards the notch in the arcade stick!
- Print flat on the bed, no supports needed.
- A .28mm layer height is recommended, smaller layer heights will work, for larger layer heights you should verify that the screw holes are fully supported or else it'll get messy.
- PLA seemed to work fine for me; you may need to fiddle with your horizontal hole expansion in Cura or Superslicer (unavailable in PrusaSlicer) if you find diagonals hard to hit.
- ABS will likely need a very slight resize to counteract shrinkage (100.5 to 101 are good starting points in general, you want the distance between the flat sides of the outer wall to be about 52.6mm)
These should be close approximate matches for the 2 official gates seimitsu offers for these arcade sticks. If you would like other styles of gates please check out my ko-fi store!
 |  |  |  |