Fire TV Remote Case - Insignia/Toshiba (Remix)
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Protect your remote, prevent batteries from being eaten, find the remote in the depths of the couch, etc.
- Ocena
- 4,5 / 5
- Polubienia
- 58
- Pobrania
- 581
- Wydruki
- 4
- Wyświetlenia
- 2324
- Oceny
- 4
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Gadgets
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
I modified the original to be able to fit onto the replacement remotes for Insignia/Toshiba/Pioneer branded Fire TVs. The original was too short and narrow, and it did not fit properly. It also did not allow for access to the power button…
Big thanks to Thingiverse user sybernic!
This remix serves as a protective case for your replacement remotes so that it's easier to track them down when your kid gets ahold of it or the couch gets hungry.
For best results, use a low layer height, and high perimeter count. Only the bottom of the model requires infill, so just make sure you have a decent amount of top and bottom layers.
The settings I used are:
- 0.12mm layer height
- 5 perimeters
- 10% gyroid infill
- PLA 220C/55C
- NO supports needed, turn them off.
*There is a built-in support that must be trimmed off with an X-acto blade or flush cutters.
I will be printing another one in glow-in-the-dark material to help me track this thing down!
*This model is specifically for this remote, and may not fit other remotes.
https://www.bestbuy.com/site/sku/6418140.p?skuId=6418140