1 / 4
SSD adapter for 3.5" server hotswap carrier (3.5" to 2.5") — zdjęcie 1
1 / 4

SSD adapter for 3.5" server hotswap carrier (3.5" to 2.5")

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Adapter for mounting SSDs in existing 3.5" server hotswap bay/carrier/caddy

Ocena
5 / 5
Polubienia
25
Pobrania
347
Wydruki
3
Wyświetlenia
1767
Oceny
5

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Computers
Licencja
Creative Commons — Attribution — Share Alike

Adapter for mounting SSDs in existing 3.5" server hotswap bays that has some sort of bottom support. Tested on Dell, HP/HPE old-style and HPE “smart” -carriers.

  • Use 3 of the original screws to fasten the adapter
  • Insert the two small pegs at the middle of the adapter into one side of the SSD
  • Fold down the SSD against the wall of the carrier

Optionally also print one of the pegs and secure the SSD in place. I found it to be completely unnecessary for Dell carriers, probably a good idea for “smart” HPE carriers and highly recommended for old-style HP carriers. The included pegs are for 7mm high SSDs, aka most modern ones.

The adapter has a hole for fastening one or two of the fastening pegs so you don't loose them before getting around to install the adapter.

 

Printing notes:

  • No supports needed.
  • Printed in PETG, but should with fine with PLA as long as you take care to not overstress the fastening pegs. 
  • Use a small layer height for the fastening peg to make smoother and thus easier to insert, 0.08mm or so. The main adapter does well with 0.2.

Tagi