Mini Stealthburner Orbiter Switchwire mount (CRtouch)

I created a mount for the Mini-Stealthburner fan shroud and orbiter 2.0 extruder. I intended for this to be for my heavily modded Ender 3 v2. I decided to convert my Ender 3 v2 to a Voron Switchwire Style Core XZ printer. It also features an integrated mount for the CR touch.

Disclamer

I hope that people find this helpful, I simply created this for my own needs. I have tested this mount on my own printer and seems to be working great, but that doesn't mean that it's guaranteed to work on your setup. I am by no means a 3D modeling pro and still learning!

Hopefully someone can take inspiration from this to create an even better one!

Insights:

• No modifications needed to the original “Mini StealthBurner Orbiter mount by @Oleynick_266380", basically plug and play
• I printed all these prints in ASA with a .12 Fine setting in BambuStudio Slicer on my P1P
• I used 100% infill just to ensure that they are solid pieces, I'm sure you could probably get away using a smaller infill.
• I used supports everywhere
• I sliced the "X bearing block in half so that the CR touch cable can run through the center without issue. It doesn't loose any integrity for the mount.
• This mount is also compatible with the original inductive probe mentioned in the official Switchwire BOM
• Compatible with MGN12H linear rails
• You might want to mount it to the linear rail first before inserting the M3 square nuts

BOM:

• 2 M3x35 BCHS to mount the fan shroud to the mount
• 1 M3x30 BCHS to mount the fan shroud to the mount in the center
• 2 M3x40 BCHS to bind the “Mount Left & Mount Right”
• 2 M3 thin square nuts (or M3 hex nuts)
• 3 M3 hex nut
• 2 M3 5x4mm heat set inserts for fan shroud

Future Iterations:

• Sorry no wire strain relief piece for this one yet, still a WIP

Shoutout to @prasadp4009 for the integrated CR Touch mount for the Voron Stealthburner

Shoutout to @Thefahmialias_227890 for the “X Carriage” mount design for the Voron Mini-Stealthburner for the Ender 3 v2

Shoutout to @Oleynick_266380 for the “Mini StealthBurner Orbiter mount” design