Macro Dual Flash Head Adapter for Godox TT350
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
This is a macro flash adapter for the Godox TT350 meant to thread on to the end of a lens with 62mm filter.
- Ocena
- 0 / 5
- Polubienia
- 7
- Pobrania
- 34
- Wydruki
- 0
- Wyświetlenia
- 987
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Photo & Video
- Licencja
- Creative Commons — Attribution — Noncommercial
This flash adapter allows you to attach up to two Godox TT350 flash heads to the end of your camera lens and have them bounce light out roughly parallel to the lens. If you just have one flash, you can use the blocker to block the second port and help reflect more light out of the main body.
Parts:
- body (required)
- tt350_adapter (min. 1 required)
- blocker (required if only using one flash head)
- filter_adapter (required)
- nut_short / nut_long (one required, use the nut_long if also using a “hood”)
- hood_32mm (optional)
- hood_43mm_threaded (optional)
- diffuser_holder_narrow (optional)
- diffuser_holder_wide (optional)
The “hood” objects help prevent internal reflections and also increases the “pseudo-axial” effect by allowing only more direct light that is parallel to the lens to illuminate the subject. The hood_43mm_threaded adapter accepts a filter, such as a circular polarising filter for if you want to do cross-polarisation.
The two diffuser holders require you to cut out from some diffusion gel or similar material a donut shape with the outside diameter matching the outside diameter of the holding, and the inside diameter matching the diameter of the inner ring. The gel can then be fit over the small tabs to hold it in place. 5mm x 2mm magnets can be fit into the holder and the top of the body to hold the diffuser in place.
The filter_adapter has 62mm threads and should screw nicely into the end of a lens. Use a step-down adapter if you need to adapt it to a larger filter size. The smaller diameter part of the adapter is placed through the body from the back and the nut then secures it on the inside. The nut should not fully secure the adapter against the body, there is a small amount of clearance to allow the body to rotate in place without unscrewing the threads so you can position it however you need.
Print settings:
- 0.16mm layer height (either 0.10 or 0.12mm recommended for the threaded parts)
- Needs supports for the body, try to give the top of the supports a bit more clearance so they are easier to remove.