1 / 4
Vortex Gemini Larger and Angled Curtain Fan Ducts - With heated inserts holes
Zamów wydruk tego modelu
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Just a modification to direct the flow of air better to the part and to gain more adjustment capabilities.
- Ocena
- 0 / 5
- Polubienia
- 14
- Pobrania
- 49
- Wydruki
- 0
- Wyświetlenia
- 370
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Printer Parts & Upgrades
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
SzczegółyPliki (4)Wydruki i komentarze (Wydruki: 0) (Komentarze: 0)Remiksy (0)Kolekcje (16)Powiązane
What has been done:
- Enlarged the duct tip (12 mm)
- Angled the top part of the tip to help redirect the flow.
- Angled the part that goes to the extrusion, so the duct points downwards a little bit more (only the versions that do not say “non angled”).
- Increased the lenght of the mounting holes to give more liberty. Now you can position the ducts nearer or farther of the heated bed.
- Added heated insert holes - Prevent the wearing of the duct holes after removing and putting the fans. Also enlarged the holes for allowing the use of larger screws.
I recommend to use support and to not turn the models!
Sorry but the “angled versions” were a bit difficult to make. The issue was with the right model, so what I did was to just clone the left one, mirror it to the other side and replace the mounting. It works great, but you might see some skin issues in the outside. I modified the STL in tinkercad.