1 / 2
Corner LED - Clicks Together
Zamów wydruk tego modelu
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
This is a corner LED with no screws to create an ambient light source in a room. Looks very clean.
- Ocena
- 0 / 5
- Polubienia
- 7
- Pobrania
- 33
- Wydruki
- 0
- Wyświetlenia
- 304
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Wall-mounted
- Licencja
- Creative Commons — Attribution — Share Alike
This Corner LED is a very simple design that prints pretty quickly. I printed it on a Bambu X1 but if you have a smaller build plate then I would scale down all the parts equally to fit. On the Bambu, I had to print them at an angle flat.
They attract to the corner of the wall via TWO push pins at the top and bottom of the extending arms. I just put some hot glue in the hole and stuck a push pin in.
For this build, I used an ESP32 and WLED to get more effects and uses out of my light.