[WIP] Longer Orange 10 - 120mm Fan Conversion
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Not Satisfied with another adapter found on Thingiverse, I decided to make my own. !!!
- Ocena
- 0 / 5
- Polubienia
- 1
- Pobrania
- 34
- Wydruki
- 0
- Wyświetlenia
- 600
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Printer Parts & Upgrades
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
Not Satisfied with another adapter found on Thingiverse, I decided to make my own.
!!! Design and instruction are still a work in progress. At this point I printed one set of v0 and it is waiting for time to be tested !!!
Goal:
- Replace the ultra noisy 60mm OEM Longer Orange-10 Fan.
- Use a standard 120mm CPU fan laying around my spare parts.
- Keep the original metallic bottom plate.
- Minimize or avoid any additional screw / reuse screw from OEM bottom.
- Make it customizable with optional side-panels.
Print instructions
Category: 3D Printer Parts Summary
Not Satisfied with another adapter found on Thingiverse, I decided to make my own.
!!! Design and instruction are still a work in progress. At this point I printed one set of v0 and it is waiting for time to be tested !!!
Goal:
- Replace the ultra noisy 60mm OEM Longer Orange-10 Fan.
- Use a standard 120mm CPU fan laying around my spare parts.
- Keep the original metallic bottom plate.
- Minimize or avoid any additional screw / reuse screw from OEM bottom.
- Make it customizable with optional side-panels.
Post-Printing
Assembly
The Funnel-Top is used to maintain the cable and to be installed in place of the original fan.
The Bottom-adapter goes on the bottom of the printer and is fixed to the metallic plate using the 4x M3 L8 screws taken from the original rubber feet fixation.
WARNING
Replacing a small, noisy, and high flow fan by a bigger fan allow to have more choice of quite fan but every 120mm CPU fan will not be suitable. Take care to choose a fan that have enough air flow to match the OEM one (wich is a noname, no-spec, chineese one...)
Be careful to the working temperature of your printer BEFORE and AFTER the conversion.