Food Chute for PetSafe Smart Feed Automatic Pet Feeder
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Single food chute for the PetSafe Smart Feed Automatic Pet Feeder.
- Ocena
- 5 / 5
- Polubienia
- 16
- Pobrania
- 125
- Wydruki
- 1
- Wyświetlenia
- 1633
- Oceny
- 2
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Pets
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
Single food chute for the PetSafe Smart Feed Automatic Pet Feeder. I was using the original splitter version of this with two chutes, and that works great for two bowls of food. Unfortunately we are now down to one cat, so I remixed the original model to have only one chute.
You can go without any chute when using only one bowl, but the food tends to go all over and make a mess. This helps direct the food into the bowl and keeps the feeder area clean. Food no longer spills on the floor.
Assembly is the same as the original Food Splitter model. Insert the main part into the base, and then position the lip of the base under the feeder.
Print Settings
Printer: AnkerMake M5
Filament: PLA+
Infill: 20% Gyroid
Perimeters: 5
Solid Layers: 5 top, 4 bottom
Supports: I used organic supports only on one small bridge. Attached a picture to show where.
Layer Height: 0.2mm