IKEA KALLAX RAISER.26 - 26mm feet
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
IKEA KALLAX 26mm feet to raise the new model to match the height of the old one
- Ocena
- 5 / 5
- Polubienia
- 37
- Pobrania
- 168
- Wydruki
- 1
- Wyświetlenia
- 829
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Living Room
- Licencja
- Creative Commons — Attribution — Noncommercial
If you're a fan of IKEA furniture, you may have encountered a situation where you have an old and a new version of the same product, and they don't quite match up. This was the case for me when I had both an old and a new IKEA KALLAX 2x2, but found that the new model was slightly shorter than the old one.
To solve this problem, I decided to model and print some simple and sturdy feet to raise the new model to match the height of the old one. I settled on a height of 26mm, which would bring the new KALLAX to the same height as the old one.
Print with at least 3 perimeters and 20% Grid infill. The screw hole should fit any m4 (4mm wide) screw. I recommend ironing the topmost layer to ensure stability!
Print well and post your makes!