1 / 2
Ender 3 + Ender 5 (Regular and Pro) Display Holder
Zamów wydruk tego modelu
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
(Yet another) stand to hold the Ender screen, letting you move it to the front of your printer.
- Ocena
- 5 / 5
- Polubienia
- 15
- Pobrania
- 113
- Wydruki
- 1
- Wyświetlenia
- 651
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Creality Parts & Upgrades
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
SzczegółyPliki (1)Wydruki i komentarze (Wydruki: 1) (Komentarze: 1)Remiksy (0)Kolekcje (14)Powiązane
The display is at a fairly steep angle to allow clearance behind, in case you've relocated your print bed. The back of the display's IDC socket (i.e: not allowing for the IDC cable) is only 20mm inside the frame.
Extra parts required:
- Two M5*8 bolts (slightly longer or shorter probably OK, too)
- Two M5 T-Nuts
You'll need to assemble it in this order:
- M5 bolts and T-Nuts
- Screw into frame
- Put in display, and screw in display
- Add knob
Notes:
- I printed it with what Cura calls “supports everywhere”, as the guide “bump” has a bit of overhang otherwise.
- You'll may need to buy or make a longer 10-way IDC cable, since you're moving the display.
- If you lose track, like I did, it's the “EXP3” connector you use on the display for the Ender 5 Pro (and likely the same for other Ender 3 and 5 models as well.)