MagSafe Charging Mount for Cooler Master Qube 500 Case
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
This sleek MagSafe mount is designed to perfectly mount your iPhone to the front of your Cooler Master Qube 500 Case
- Ocena
- 0 / 5
- Polubienia
- 18
- Pobrania
- 56
- Wydruki
- 0
- Wyświetlenia
- 575
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Portable Devices
- Licencja
- Creative Commons — Attribution
This sleek MagSafe mount is designed to perfectly mount your iPhone to the front of your Cooler Master Qube 500 Case.
Any MagSafe charger with a three foot cable will be able to reach the Qube 500 PC Case's rear I/O allowing charging whenever the PC is on when routed under the case as shown in the renderings.
Print Settings:
Orientation: The model has been pre-orientated so that it is at its ideal printing position.
Supports: Two small supports are necessary to support the bottom portion of each case clip. I left built-in supports off of the model as I know many users have different preferences but the supports are required. Other supports may be required in a few areas if your printer does not handle overhangs well however most Prusa and Creality machines will handle these fine.
Infill/Material/Quality Settings: Up to you! The design does not require very specific slicer settings with the exception of supports.