FT-5 OptiCooler for 713Maker Ultralight and Stock Hotend
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
This is a remix of printingotb's OptiCooler for the Folger Tech FT-5. I am running the 713Maker Ultralight carrier…
- Ocena
- 0 / 5
- Polubienia
- 0
- Pobrania
- 12
- Wydruki
- 0
- Wyświetlenia
- 107
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Accessories
- Licencja
- Creative Commons — Attribution — Noncommercial
This is a remix of printingotb's OptiCooler for the Folger Tech FT-5. I am running the 713Maker Ultralight carrier with the stock MK9 hotend for now, but it may also work with the Titan Aero extruder. The fan bracket simply mounts to the extruder stepper itself on the bottom two screw. Remove the screws and replace with 5mm longer screws. You may need a washer or 2. I also recommend printing the arms out of PETG or ABS with their proximity to the heater block.
This setup runs two 5015 radial fans wired together. Check original file for more info. I zip-tied them together to keep them in line.
NOTE: Adjust nozzles down as close the the bottom of the nozzle as possible without interfering with the print.
Print Settings
Printer:
Folger Tech FT-5
Rafts:
Doesn't Matter
Supports:
No
Resolution:
0.16mm
Infill:
30%
Category: 3D Printer Accessories