1 / 5
Vinyl Fencepost rail jigs and covers — zdjęcie 1
1 / 5

Vinyl Fencepost rail jigs and covers

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Jigs to route rail holes in vinyl fenceposts; covers for old rail holes

Ocena
0 / 5
Polubienia
5
Pobrania
64
Wydruki
0
Wyświetlenia
315
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Licencja
Creative Commons — Attribution

When we built our house, we didn't think we'd need a gate in the privacy fence, but later changed our minds. My builder charges over $800 for a gate, and they use some proprietary rail sizes that I couldn't find anywhere.  So I decided to repurpose an existing 3-ft section of fence to make my own gate:
- I bought 2 new 4x4" vinyl posts for the gate uprights which needed new holes for the old fence rails. I clamped the jigs in place and a top-bearing flush trim bit to route out the holes. 
- The existing 5x5 fence posts became the gate posts with the addition of 5x5 aluminum stiffeners and gate hardware. I covered the old rail holes with these custom PETG covers.
-  I designed the jigs and covers in F360 using parameters so you could modify the .f3d files if you need different sizes. I also designed the gate in F360; let me know if you want that file.
- Total cost was less than $250 and a few days work.

Jig Settings:
Filament Prusament PLA
Nozzle 0.6
Layer 0.35mm
Supports no
Fill 10% gyroid
Perimeters 2
Temp 215

Cover Settings
Filament Generic PETG
Nozzle 0.6
Layer 0.20mm
Supports no
Fill 15% gyroid
Perimeters 2
Temp 230C/240C

Tagi